Author: admin

Next Post Coming Soon…▶ Speed loaders are the superior revolver reloading device. They’re faster and easier to use. No they aren’t…speed strips are. They’re easier to carry and allow you to top off your wheel gun. That’s what I imagine the comments section of articles on revolvers would look like any time between the 1970s and 1992 (if there were comment sections back then), from the advent of the Speed Strip by Bianchi to the takeover by Wonder Nines. That argument doesn’t seem to pop up much today for obvious reasons, but if it did, something like the Zeta6 K-Clip…

Next Post Coming Soon…▶ The APX A1 Compact is Beretta’s mid-size addition to their striker-fired, 9mm carry gun market. It has quite a different look than the 92’s I’ve long associated Beretta with, joining the APX family Beretta has worked hard to refine over the last several years. At 27.7 ounces unloaded with a 3.7-inch barrel, it’s significantly heavier than the smaller APX A1 Carry (3-inch barrel) subcompact with a longer barrel…but a mere 1.3 ounces lighter than the APX A1 Full Size with its 4.25-inch barrel. Being right between both offerings, would Goldilocks consider it “just right?” Like it’s…

Next Post Coming Soon…▶ I’ve done a fair bit of AR builds and mods over the years culminating with a flurry of them this summer. I’ve used an old plastic clam shell upper receiver block, and for the most part it’s been fine. I’ve occasionally run into an upper profile that doesn’t fit the block though, and more recently had a couple barrels that must have been torqued on by gorillas. I could see the aluminum upper flexing in the vise and backed off before I damaged something. I started looking around at other options and came across various reaction…